Heating Bending Machine Use For Plexiglass Acrylic Pvc ABS PC Plastic Sheet Bending

1. The machine water cooling system is made of 304# stainless steel material to ensure that it is not deformed for a long time.
2. The machine is equipped with an automatic alarm device for water temperature to remind you to change the water source.
3. Infrared constant temperature heating method, the workpiece is evenly heated, instantly softened and bent, and cooled and formed.
4. This machine can fold 2 corners at the same time and fold 180 degrees at the same time. It can be controlled by a single work surface and humanized design.

Automatic bending machine installation and operation methods:
1. Before using the machine, read the instructions in detail, and follow the power supply instructions for 380V or 220V. It must be used according to the
relevant electrical regulations for reliable grounding.
2. Installation environment: The equipment should be installed on a flat, well-ventilated ground.
3. It is necessary to configure a 2.2KW air compressor or pipeline compressed air. The minimum guarantee is 0.6Mpa and the air pipe interface is 8M



Parameters